RIASSUNTO
Sliding between asperities occurs inevitably in the friction pair, which affects the efficiency and reliability in both lubricated and non-lubricated conditions. In this work, the contact parameters in the coated asperity sliding process are studied, and the universal expressions of the average contact force and the friction coefficient are obtained. The effect of the interference between asperities, the material and geometrical parameters including the Young’s modulus ratio and yield strength ratio of the coating and substrate, and the hardening exponent and thickness of the coating on the average contact forces and friction coefficient is considered. It shows both normal and tangential contact forces increase with the increasing interference, increasing Young’s modulus ratio, decreasing yield strength ratio, and decreasing coating thickness; while the trend is different for the effect of the hardening exponent of the coating. The normal force increases and the tangential force decreases as the hardening exponent increases. Based on this, the influence of these parameters on the effective friction coefficient is obtained further. It reveals that the friction coefficient increases as the interference and Young’s modulus ratio enlarge and decreases as the yield strength ratio, the coating’s hardening exponent, and thickness increase. The universal expressions for the contact force and friction coefficient in the sliding process are obtained. This work might give some useful results to help choose the optimum coatings for specific substrates to reduce friction in cases where the asperity contact exists, especially in the focused field of the journal bearing in the marine engine under poor lubrication conditions.